Recmar CurtainMate™
Wall Track

-Back to Recmar Products-

CurtainMate curves easily by hand.
NOTE: When installing with the maximum 5" arc, or a severe bend, relieve the stress by warming in hot water.

TRACK 5400 WALL MOUNT
3 FEET $11.00 EACH 36”LENGTH (01 WHITE) (02 BROWN)
(03 GRAY)(04 BLACK)

5034-P: FOR 5400 TRACK END CAPS, PLASTIC:
$3.00 PER BAG OF TWO
(01 WHITE)(02 BROWN)(03 GRAY)(04 BLACK)(21 TAN)
(24 DARK DESERT)(25 DARK SLATE)

SNAP CARRIERS 3070-1:
$6.00 PER BAG OF 14 (01 WHITE)(04 BLACK)
3091Y SNAP TAPE 4 ¼” SPACING $5.00 PER YARD

SNAP CARRIERS SNAP TAPE 3091Y-1:
4 1/4" SNAP SPACING, 1" WIDE, POLYESTER
(06 OFF WHITE) (04 BLACK) (03 GRAY)
$6.00 PER YARD

When a severe bend or the maximum 5" arc (as shown in figure 4) is called for, the installer may wish to use sheet metal screws or 1/8" guide studs (as shown in figures 2 & 3) in the blind holes in the rear of the track. These additional fasteners or guide studs will maintain a smooth bend and/or the desired contour.

Click For
Fabrication Chart

5034 End Cap 3070 Snap Carrier Tape

No. 5034 end-cap: Rust proof and non-corrosive. Serves as an end-stop, finishing-cap, track-end, and curtain return anchor.

Unique track ends fit firmly together end on end to form any desired drapery track length, up to 72". Allow 5/8" to install end-cap, and cut final track section to fit space requirements.